Boring & Milling Head Unit
Spindle type of the XT30-2 spindle head .
NT30 is the traditional type with the taper of 7:24 and cutter installed with rear axle rod.
MT3# taper-shank with flat tail can be directly placed.
ER32 clamping cutter with straight shank Φ2-Φ20mm.
The motor power and speed can be configured with speed ratio of triangular belt, synchronous belt and poly V-belt
according to the requirement.
The customization of power head with special specification can be accepted.
The front loading of left side for 90° /front loading of right side for 90° , back loading of left side for 90° /back loading of
right side for 90° and downward preposition/downward postposition can also be carried out in the configuration direction of
motor box.
上一篇:简析双头数控车床对刀的方法和技巧
- 凡本网注明"来源:机床商务网"的所有作品,版权均属于机床商务网,转载请必须注明机床商务网,//www.jc35.com/。违反者本网将追究相关法律责任。
- 企业发布的公司新闻、技术文章、资料下载等内容,如涉及侵权、违规遭投诉的,一律由发布企业自行承担责任,本网有权删除内容并追溯责任。
- 本网转载并注明自其它来源的作品,目的在于传递更多信息,并不代表本网赞同其观点或证实其内容的真实性,不承担此类作品侵权行为的直接责任及连带责任。其他媒体、网站或个人从本网转载时,必须保留本网注明的作品来源,并自负版权等法律责任。
- 如涉及作品内容、版权等问题,请在作品发表之日起一周内与本网联系,否则视为放弃相关权利。