WSU型重切削可调多轴器
WSU type heavy cutting adjustable multi-axis device
３、工作时应经常加润滑油脂 WSU type heavy cutting adjustable multi-axis device(multi-axis driller/multi-axis drill/multi-axis drill/group drill) structure composed of gear box with universal joint head, easy to adjust, processing hole distance is not limited by gear, save adjustment time, There are also few limitations on the dead angle. SWU-type series multi-axle heads have powerful series of bearings, Gears, output shafts, and cardan joints, which are suitable for processing steel parts and other powerful occasions. SWU series multi-axle head for the life of the universal node, the range of movement must not exceed 15 degrees, equal to the vertical front and rear about 30 mm or less 型号 SWU110 SWU165 SWU200 SWU250 SWU100×165 SU120×200 SU120×300 筒夹规格/ ER20/13 ER20/13 ER20/13 ER20/13 ER20/13 ER20/13 ER20/13 转速比 1:1 1:1 1:1 1:1 1:1 1:1 1:1 两轴*小间距 42 42 42 42 42 42 42 *大轴心范围 110 152 190 240 90×152 106×190 10×290 轴数 2-8 2-10 4-12 4-12 3-18 4-12 6-14 
◇WSU型重切削可调多轴器（多轴钻孔器/多轴器/多轴钻/群钻）结构利用齿轮箱配合万向节头所组成，容易调整,加工孔距不受齿轮限制，节省调整的时间，也少有死角的限制，SWU型系列多轴头其轴承、齿轮、输出轴、万向节均采用强力系列，适合加工钢件等强力场合。SWU型系列多轴头为保万向节头这寿命，移动范围不得超过15度，等于垂直这前后左右30mm以内
（尽量配合工作之孔距坐标，设计齿轮箱结构即定镗孔位）
※WSU型重切削可调多轴器万向节注意事项：
1、调整时不能超过规定的角度15度
２、如超过些极限心轴易磨损或断裂
(As far as possible with the working hole distance coordinates, the design gear box structure is fixed boring hole position)
WSU type heavy cutting adjustable multi-axis device universal joint note:
1, adjustment can not exceed the specified angle 15 degrees
2, if more than some limit of the axis easily wear or break
Always lubricate your work with grease
钻孔能力
ER25/16
C12/12
ER25/16
C12/12
ER25/16
C12/12
ER25/16
C12/12
ER25/16
C12/12
ER25/16
C12/12
ER25/16
C12/12
45
45
45
45
45
45
45
